power manager an error occurred while loading resource dll

Power manager an error occurred while loading resource dll windows#

Here’s a step-by-step guide through the whole thing:

If the utility determines that the ports are not being used, we’ll examine the ListenOnlyList subkey to see if it’s correctly configured. To resolve this issue, we’ll need to deploy the Netstat.exe utility in order to determine if another process is using the ports specified above.

Another process is using the TCP port (80) or the SSL port (443) required by the IIS.

The ListenOnlyList registry subkey is not configured correctly on the IIS running computer.

Based on the official Microsoft documentation, the error message will appear if one of the following conditions are applicable to your current situation: This issue is quite common with computers running Microsoft IIS 6.0 and 7.0. If you are encountering the issue while trying to right-click a website item inside the IIS MMC snap-in (clicking Start doesn’t do anything), you’ll need to use the Netstat.exe utility to figure out if another process is using port 80 and port 443. Method 3: Resolving the IIS port conflict If this method didn’t resolve the conflict or wasn’t applicable to the situation that you’re encountering, move down to the final method. Note: Ensure that the terminal you’re running the command in has admin privileges. Netsh int ipv4 set dynamicport udp start=10000 num=1000 Several users struggling to resolve the same error message have found that the conflict is resolved after they tried to set a completely different IP range instead of creating an exclusion range.īelow you have a couple of commands that one affected user successfully ran to resolve a conflict between DNS and Quickbooks: netsh int ipv4 set dynamicport tcp start=10000 num=1000 If you’re trying to resolve a conflict DNS conflict using netsh and the method above didn’t help you, you might want to try a different approach. If you’re still getting the “ The process cannot access the file because it is being used by another process” error or this scenario wasn’t applicable, move down to the next method below.

In the elevated Command Prompt, run the command again and see if you’re still encountering the same error message.

When prompted by the UAC (User Account Control), click Yes to grant admin privileges.Opening an elevated Command Prompt window Then, type “ cmd” and press Ctrl + Shift + Enter to open up an elevated Command Prompt.

Power manager an error occurred while loading resource dll windows#

Press Windows key + R to open up a Run dialog box.

To ensure that the CMD window you’re trying to perform the action in has admin privileges, follow the steps below: Keep in mind that an operation of this kind will require administrator privileges. This is reported to occur more than often when the user tries to run a command that adds exclusions to the dynamic port range for native Windows apps or 3rd party application. If you’re getting this error when trying to run a netsh command, it’s likely that the error is occurring because you don’t have admin privileges. Let’s begin! Method 1: Running the command with admin privileges Down below, you have a collection of methods that other users in a similar situation have used to get the issue resolved.įor the best results, follow the methods below in order until you encounter a fix that is effective in resolving the error in your particular scenario. If you’re currently struggling to resolve this particular error message, this article will provide you with a collection of verified troubleshooting steps.

The ListenOnlyList registry subkey is not configured correctly – Another common scenario with IIS (Internet Information services) that will trigger this particular error is an incorrectly configured ListenOnlyList registry subkey.

If another process is using these two ports, you will see this error message.

Another process is using port 80 or port 443 – This is typical with computers running IIS (Internet Information Services).Several users in a similar situation have managed to get the issue resolved by granting admin privileges. The command requires admin privileges – If you’re encountering the error inside a terminal, it’s most likely because you don’t have administrative privileges to make the modifications.